Boston Acoustics Horizon i-DS2 - Manual (Page 5)

5
The i-DS 2 Controls
Turns the Horizon i-DS 2 on and off. The button is lit when the i-DS 2
is on. The button blinks when the sound is muted.
–/+
Increases or decrease the volume level.
When your iPod is docked in the i-DS 2 the jog wheel does not change
the volume. The iPod navigation controls – > , , , { and } work as they
normally do.
About the Remote Control
The supplied remote control is usually the most convenient way to operate the i-DS 2 .
Press to turn the i-DS 2 on or off.
Press to start play or pause play.
Press to increase sound volume. Press and hold for faster adjustment.
Press to decrease sound volume. Press and hold for faster adjustment.
Press to mute, or un-mute, the sound. When the sound is muted the light in the
main power button blinks.
Press once to skip to the next track. Press and hold to scan forward within a track.
Press once to return to the beginning of the current track. Press twice to skip to the beginning of the
previous track. Press and hold to scan backward within a track.
note: When you unpack your remote control there will be a plastic insulation tab extending from the battery
compartment. Pull out this tab before using the remote control.
There must be an unobstructed line of sight to the front of the i-DS 2 when using the remote control. Point
the remote control at the front panel of the i-DS 2 . when pressing the buttons. For best results you should be
within 20 feet of the unit and no more than 45° off axis. Being in a brightly lit room can reduce the sensitivity
of the i-DS
2 to remote control commands.
note: Eventually you’ll need to replace the remote battery. If the remote doesn’t reliably operate the i-DS 2 ,
put in a new CR2025 3V lithium coin type battery.