Bard ECONOMIZERS WITH EXHAUST EIFM-5C User Manual
Page 5
Manual 2100-447C
Page
5 of 13
IMPORTANT: Position front lip of economizer on
top of front grille and condenser partition (See
Figure 2 inset.) This is important to ensure proper
drainage of any water entering damper assembly.
LEFT HAND UNITS – Slide the economizer to
the left until it is tight against the back of the corner
panel.
6. Mount mixed air thermistor to blower partition with
screws provided. Bracket with sensor installs on
top of blower partition and screws are installed
from the underside. Route wires as shown and
secure with wire tie. Connect wires to thermistor.
(See Figure 2.)
7. Open unit control panel to gain access to unit low
voltage terminal block.
8. FOR LEFT HAND UNITS – Reroute economizer
wiring harness to the left side of the economizer.
(See Figure 3.)
9. Route electrical harness leads through the 7/8"
bushing in control panel (Figure 2) into low voltage
box.
FIGURE 2
TOP VIEW OF
BLOWER PARTITION