GAM SX4 DMX LOOP TRAY TS6111 - Manual (Page 2)

STAND ALONE OPERATION
For use of Loop Tray without DMX or desk control, set mode switch to 0,5,6,7,8 or 9. There is no fan speed control in
any stand alone operation mode.
Page 2 of 2 www.rosco.com
MODE 2 - TWO CHANNEL OPERATION
For use with DMX control; loop speed and direction.
MODE 3 - TWO CHANNEL OPERATION (with fan ctrl.)
For use with DMX control; one channel each for speed,
direction and fan speed control.
Loop Speed:
0-40 = Forward direction, full to slow speed
41-59 = No loop motion
60-100 = Backward direction, slow to full speed
Fan speed control
MODE 4 - THREE CHANNEL OPERATION (with fan ctrl.)
For use with DMX control; one channel each for speed,
direction and fan speed control.
Channel Controls
1
2
Loop Speed:
0 = No movement
100 = Full motor speed
Loop Direction:
0 – 35 = Forward loop direction
36 – 64 = No movement
65 – 100 = Backward loop direction
Channel Loop Speed and Motion
0 No Motion
1 Full speed rotation in forward direction
2 – 39 Decreasing rotation speed in forward direction
40 Forward motion stopped
41 – 59 No Motion
60
Slowest motion in backward direction
61-99 Increasing rotation speed in backward direction
100 Full speed rotation in backward direction
Channel Controls
1
2
Loop Speed:
0 = No loop speed
100 = Full speed loop motion
Loop Direction:
0-35 = Forward loop direction
36-64 = No loop direction
65-100 = Backward loop direction
Fan Speed
Channel Controls
1
2
3
The Loop that is being projected should be installed
upside down. Power is applied through the 4-pin XLR
connector using the TSPS-20 power supply or TSPS-80
power supply or appropriate power supply.
MODE 1 - ONE CHANNEL OPERATION
For use with DMX control; select 1 on Mode Switch. Set
DMX address on Loop Tray to desired control channel.
Direction Speed Operation
Mode X100 X10 X1
0, 5, 6, 7, 8, 9 Any even number 2 0 Slow speed Loop rotation, forward direction
0, 5, 6, 7, 8, 9 Any even number 5 0 Half speed Loop rotation, forward direction
0, 5, 6, 7, 8, 9 Any even number 9 9 Full speed Loop rotation, forward direction
0, 5, 6, 7, 8, 9 Any odd number 2 0 Slow speed Loop rotation, backward direction
0, 5, 6, 7, 8, 9 Any odd number 5 0 Half speed Loop rotation, backward direction
0, 5, 6, 7, 8, 9 Any odd number 9 9 Full speed Loop rotation, backward direction
X10 Switch = Coarse loop speed rotation adjustment
X1 Switch = Fine loop speed rotation adjustment