Bear Archery Compound Bow 2010 - Manual (Page 18)

18
CAM ADJUSTMENTS
Adjusting Draw Length – Rotating Modular
Cam System with MultiDraw
The adjustable multidraw cam equipped bow can
be configured to provide a draw length from 14”
to 27” in 1” intervals. No bow press is required
to adjust the multidraw cam system. To adjust
the draw length, first remove the socket head cap
screw located in the rotating module. Next rotate
the module to the desired draw length and
reinstall the screw in the corresponding hole. It
may be necessary to pull the cable away from the
module to provide clearance for the module to
rotate, see the picture below. Next perform the
same operation on the opposite cam. Be sure that
both the top and bottom cams are set to the
same draw length position. The adjustable cam
operates on a sliding poundage scale where an
increase in draw length also provides an increase
in peak draw weight. This allows the bow to
grow with the archer. The chart below shows the
peak draw weight at each draw length for the 40
and 50 pound peak bows.
Back View Front View
Draw Length
printed on
module
Right or
left hand
designation
Module
Mounting
Screw
Cam