Battery Tender 480 CCA Lithium Engine Start Battery (PN BTL35A480C) - Manual

1
IMPORTANT SAFETY INSTRUCTIONS
1) SAVE THESE INSTRUCTIONS
2) Do not throw away the box or any foam packing until after the installation is
complete.
CAUTIONS
a) Do not immerse in water.
b) Do not short terminals together.
c) Do not use or store the battery near sources of fire or heater.
d) Do not reverse the positive (+) or negative (-) terminals.
e) Do not put the battery into a fire or apply direct heat to it.
f)
Do not pierce the battery casing.
g) Do not strike, throw, or subject the battery to sever physical shock.
h) Do not solder directly to the battery terminals.
i)
Do not attempt to modify the battery in any way.
j) Do not place the battery in a microwave oven or pressurized container.
k) Do not use the battery if it gives off an odor or generates heat.
l)
Do not allow charge voltage in excess of 14.8Volts.
m) DO NOT use the battery in temperatures below -10ºC (14ºF).
n) Do NOT use lead-acid chargers which employ a high-voltage “anti-
sulfation” routine.
o) Keep batteries away from pets and children.
p) Fully discharge before disposal.
WARNING
a) Be extra cautious to reduce risk of dropping a metal tool onto battery. It
might spark or short-circuit battery or other electrical parts that may cause
explosion.
b) Remove personal metal items such as rings, bracelets, necklaces, and
watches when working with any battery. A battery can produce a short-
circuit current high enough to weld a ring or the like to metal, causing a
severe burn
.
c) To reduce risk of battery explosion, follow these instructions and those
published by the manufacturer of any equipment you intend to use in
vicinity of this battery. Review cautionary markings on these products and
on engine.
Deltran Battery Tender ®
LITHIUM IRON PHOSPHATE BATTERY
392-0255-R0
2
INSTALLATION INSTRUCTIONS
a) Carefully remove the existing lead-acid battery from your vehicle following
the manufactures guidelines.
b) Next place the original battery next to your Battery Tender® Lithium
battery to compare the variation in size. The original battery may be the
same width but is longer in length and taller in height. To make up the
difference apply the appropriate amount of the adhesive foam to either the
Lithium battery or the battery box.
c) Ensure the battery now fits surely in the battery box and allows the battery
cables to reach the battery terminals with no issues.
d) The Battery Tender® Lithium battery allows the cable eyelets to be either
connected from the top or front side of the terminals. Choose the side that
matches your configuration the best.
e) Use the supplied hardware to attach the terminal rings to your battery. Do
not over-tighten the screws. (See diagram above)
FOAM
FOAM
FOAM