Barranca Diamond PF10 Power Feed Trim Saw - Manual (Page 11)

11
CONTENTS
In the shipping crate, you will find one Barranca Diamond PF10 Trim Saw assembly (saw, motor, baseboard,
spray hood and 10" x 0.040 x 5/8 303 Pro diamond blade). One package of six rubber feet and mounting
screws, and one 1" x 1" x 6" sharpening stick.
UNPACKING AND ASSEMBLY
Your PF10 Trim Saw has been shipped from the factory thoroughly inspected and tested. Remove the crating
material (wood and plastic) from the baseboard and around the saw with a Phillips and standard screwdriver
and box cutter knife. Remove the spray hood from the saw and remove the protective covering from either side
of the acrylic window.
Once removed from the crate, locate the six rubber feet and screws in a zip-lock plastic bag. Each rubber foot
mounts to the underside of the baseboard in predrilled mounting holes. This step should be performed before
sawing lubricant is added to the oil reservoir. To mount the feet, first remove the two Phillips-head machine
screws that secure the belt guard to the saw table. Then, while supporting the left (vise) side of the saw table,
remove the four flat-head machine screws (fig 1) that secure the saw table to the reservoir tank and remove the
saw table. Please note: the saw table will fall off the reservoir if not supported once the final mounting screw is
removed! . At this point you can reattach the saw table and belt guard, or continue to the start up section of this
manual (page 9).
Fig 1. Removing the saw table from the reservoir tank Fig 2. Installing the rubber feet
TRANSPORT
For ease of transport, place the hood window over the saw table and tape the hood to the table to prevent
vibration from scraping the paint off both the table and hood during travel. All sawing lubricant should be
removed from the reservoir during transport of the saw.
PF10 SETUP
Saw Assembly Sharpening Stick Rubber Feet and
Mounting Screws