Barranca Diamond HP18 Slab Saw - Manual (Page 18)

18
MAINTENANCE FOLLOWING USE
The following maintenance should be performed following each use.
Blade-Shaft Bearings
Remove sheet metal cover over blade shaft
and grease zerk fittings on base mount bear-
ings. Use premium wheel bearing grease to
lubricate all blade-shaft bearings.
Shaft bearings
Cross-adjustment rail system
Cross-Adjustment Rail System
No grease or applied lubrication is required for the
stainless steel screw feed and cross-adjustment
rail system. The slab saw cutting oil splash will
adequately lubricate the vice screw-feed, rails and
clutch parts. If the
carriage becomes hard to slide over the rails, clean
the rails with a rag and apply a liberal amount of
wheel bearing grease to the surface of the steel
rails to facilitate travel of the carriage over the rails.
HP18 & HP24 MAINTENANCE
WARNING Place the ON/OFF switch in the OFF position and unplug cord prior to servicing
and when changing accessories, such as blades, belts, and the like.