Barranca Diamond BD7 Trim Saw - Manual (Page 12)

12
Power Switch
1. Check that the power switch is in the OFF position.
2. Plug-in the power cord.
Power Test
1. Move the power switch to the ON position to rotate the
blade. (Figure 6)
2. Check that the blade is rotating. This indicates the saw is
functioning properly.
3. Move the power switch to the OFF position.
Figure 6: ON / OFF Switch
Machine Damage: Use diamond blades only. Check blade for signs of core or seg-
ment cracks, uneven segment wear, pounding out of round arbor hole, undercutting,
segment loss, dishing or loss of tension. If the blade shows signs of any of these
problems the blade must be replaced before starting work. A damaged blade will
not cut correctly and could cause physical injury.
The Rock Vise is an optional accessory (Part # 169400)
CAUTION
Cross-Feed
Locking
Thumbscrew
Cross-Feed
Knob
Rock Vise
Jaws Clamp
Locking
Wing Nut
BD7 OPERATION
Figure 7: Rock Vise
The blade guard will reduce excessive splash and spray of cutting fluid during
rock trimming. It is recommended to wear personal protective gear (safety glasses,
gloves and a shop bib) during trimming.
CAUTION Do not operate without guards in place
NOTICE: