Addictive Desert Designs 2009 - 2013 F-150/Raptor Venom Rear Bumper - Manual

Addictive Desert Designs
2010 – 2013 Ford Raptor
Venom Rear Bumper
Installation instructions
PREPARATION STEPS
1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the
emergency brake set.
2. You will need the following tools:
a. 90’ drill
b. ½” drill bit
c. Ratchet
d. ¾” Socket
e. ¾” Wrench
f. 10MM socket
g. 10mm Wrench
3. Hardware Included:
a. 4 – ½” x 1 ½” Bolts
b. 4 – ½” Nuts
c. 8 – ½” Flat washers
**2 – 10mm Bolts will be re-used in the installation
INSTALLATION INSTRUCTIONS
1. Remove factory Rear Bumper.
2. Drill the 4 mount holes out to ½”.
The red arrows are the holes to be
drilled. Lower mount holes will
remain not be altered and reused.