Synergy 5011-03 - Jeep JK Front Air Bump Mounting Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5011-03 AIR BUMP STOP BRACKET KIT
INSTALLATION
Version 1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• The installation of these brackets requires the use of PPM-5011 Coil over brackets
and coil over shocks.
• The installation of this bracket requires the complete removal of the stock shock
and coil mounts on the frame and axle. A plasma cutter or oxy-acetylene torch
works but you can also use a sawz-all and cut off wheel. The new bracket must
be welded to the frame and axle tube. An experienced fabricator/welder is
recommended to properly install this bracket.
1. Refer to complete PPM-5011 coil over instructions for bracket removal and
installation of the rest of the required components
2. Tack weld the air bump mounting brackets into place. Position the back of the air
bump mounting bracket against the front of the shock brackets. The air bump
mounting brackets are left and right specific; the side with the diagonal bend is the
rear of the bracket. Put that side against the shock bracket.
a) Move the air bump bracket all the way back so it is against the front of the shock
bracket.