Installation of cyclone dryer, For your records – Heater Craft 500-014 V2 Cyclone drying systems User Manual
Page 3
Installation of Cyclone Dryer
Note: Because of the size and weight of the Cyclone Dryer most units are shipped by common motor freight. Upon receiving your Cyclone
Dryer please inspect the unit thoroughly for any damage. If the unit is damaged do not accept delivery and contact customer service at Cyclone
Drying Systems by Heater Craft (208)-687-4400.
Remove dryer from packaging and dispose of packaging properly.
1.
Dryer must be installed indoors away from standing water.
2.
Install mounting bracket to desired wall. (Don’t forget to have an outlet close enough to plug dryer in).
3.
Locate stud using a stud finder
4.
Pre-drill 5/32” hole at least 55” off the floor.
5.
Mount the bracket using one of the holes (in the bracket) to the stud.
6.
Use the anchors provided for the other hole or holes in the bracket.
7.
Once the bracket is mounted hang the Dryer on it and plug in the cord.
8.
4 & 8 Pair Bracket Mounting Instructions
Locate stud using a stud finder.
1.
Pre-drill 5/32” hole at least 55” from the floor.
2.
Mount the bracket using one of the 2 holes (in bracket) to the stud.
3.
Use the anchor provided for the other hole.
4.
Once the bracket is mounted hang the boot dryer unit on to the bracket and plug in to start using.
5.
There are 2 anchors provided if a stud is not going to be used. It is recommended that a stud is used if possible.
14 and 24 Pair Wall Mount Instructions
Kit includes 2 drywall anchors, 2 screws for them, 1 Stud screw, and 2 wall brackets.
After selecting desired location, find stud if possible for one of the brackets on the top of the dryer and
1.
mark the spots for mounting.
Place the drywall anchor in the mark where there is no stud.
2.
Place dryer back in position an screw to the wall.
3.
Note: if at least one stud is not available use both drywall anchors to attach to wall.
For Your Records
Model Number_____________________________________ Date Installed_______________________
Installers Contact Information
Name__________________________________________________________________________________
Address_______________________________________________ State___________ Zip______________
Daytime Phone_____________________________ Mobile Phone _______________________________
Email Address___________________________________ Other _________________________________
Questions?
Call for Technical Support (208)-687-4400 or Fax (208)-687-9700, www.heatercraft.com