Steele Products SP-GG750E - Manual (Page 15)

Owner’s Manual
14
Assembly
Wheel Kit Installation
Start by installing the
rubber floor mounts
onto the support leg
as shown.
Note: The leg should
be installed on the
same side as the pull
handle.
This is what the leg
looks like when it is
installed.
The wheels should be installed on the
side opposite to the handle. Place a block
of wood under the generator so that you
don’t have to hold it up while trying to
install the axle. Push the two axle mount
brackets onto each side of the axel. Place
the axle under the unit. Thread two bolts
thru the tubular frame and thru the axle
mounting plates. Thread a nut onto the
bolt and tighten.
Slide the wheels
onto the axle.
Place a washer
over the wheel
Push the cotter pin thru the axle and bend
it backwards as shown
Your generator is now mobile. Enjoy!
Here is the hardware required to install
the support leg. Place a block of wood
under the generator so that you don’t
have to hold it up while trying to install
the leg. Place the support leg under the
frame. Push the bolt thru the frame and
thru the leg. Thread a nut onto the bolt.
Tighten with a wrench.
1
3 4
5 6
2