InnoMax Luxury Support Deluxe Pump - Manual

When placing the pump under your bed, be sure to have the ports facing the wall after placing the air
cores into the cavity of your new sleep system. Looking from the foot of your bed, the right side air
core will be attached to the right port of your pump and the left side air core to the left port.
PUMP ASSEMBLY & USAGE
HEAD
FOOT
LEFT
AIR CORE
RIGHT
AIR CORE
WALL
PLACE AIR CORE
HOSES THROUGH
FOAM RAIL
PLACE
INFLATOR
UNDER
THE BED
FRAME
WITH THE
PORTS
FACING
THE
WALL.
RIGHT
PORT
LEFT
PORT
LUXURY SUPPORT ® DIGITAL DELUXE
AIR PUMP CONTROL OPERATION
Luxury Support® Deluxe: 1 Wand, 3 Function (Up/Down/Memory), Dual System
1) Initial Setup Fill: Press and release Memory key twice. Shortly after releasing Memory key the second time,
pump will begin filling chamber. Factory preset is 50 mm/Hg. Repeat step one for other chamber if system is dual.
Only one chamber may be filled at a time.
2) Manual Mode: Soft/Deflate or Firm/Inflate keys may be pressed to manually set desired sleep
preference.
3) To Reset Memory For Sleep Preference: Press Soft/Deflate or Firm/Inflate to desired level. Press Memory key
and hold Memory key until LED readout shows set point for sleep preference. Once Memory is set, to return to set
preference, press and release Memory key twice and pump will adjust chamber accordingly shortly after key is
released the second time. Repeat step three for other chamber if system is dual.
4) Pump will stop operating at Memory set point or at 50 mm/Hg or if “hi” is displayed on readout or if pump has
been running continuously for 10 minutes.
5) Energy Efficient Mode: Display lights to turn off 5 minutes after use and relight after any keys are pushed.
PLEASE NOTE: While filling chambers it is normal for your Luxury Support® pump to turn off and on
intermittently as it is allowing pressure to balance between pump and chambers to ensure accurate
support set point readings.
POINT
CONTROL
TOWARDS
FOOT
WHEN
FILLING TO
INFLATE
CORRECT
SIDE OF
BED.