Blaupunkt BERGAMO RCR 148 - Manual (Page 13)

34
Manual tuning:
•
Press << >>; the frequency will change
in short intervals in downwards or up-
wards direction.
When holding the right or left part of the rock-
er switch depressed, the frequency scan is
speeded up.
Scrolling through the broadcast-
ing networks
(FM only)
You can use the << >> buttons to tune in
stations of your reception area.
If several programmes of the broadcasting
networks can be received, you can scroll
through them in forwards direction pressing
>>, or backwards using the << button, e.g.
NDR 1, 2, 3, 4, N-JOY.
For this it is necessary that the stations have
been tuned in at least once and that “AF” is
active (lights up in the display).
For this purpose, start automatic tuning, e.g.
using Travelstore:
•
Press FM T or BND for 1 sec.; the
system starts to run through the fre-
quency band. The display shows
“T-STORE”.
If “AF” does not light up,
•
press AF.
This fulfils the requirements for selecting
stations with << >>.
Station tuning
Automatic tuning /
• Press / ; the car radio will automati-
cally search for the next station.
When keeping the upper or lower part /
of the rocker switch depressed, seek tuning
will speed up in upwards or downwards di-
rection.
Seek tuning
Up
Down
<< / >> Up/Down in short intervals
(FM only, “AF” must be switched off)
Manual tuning with << >>
You can also tune in a station manually.
Condition:
AF and PTY must be switched off (i.e. the
symbols do not light up in the display).
If necessary, deactivate these functions:
•
Press AF or PTY briefly.
Changing the memory bank
You can shift between the memory banks I,
II and T in order to store stations and recall
them later.
The currently selected memory bank is in-
dicated in the display.
•
Press the FM T or BND button as many
times until the desired memory bank
lights up in the display.
Storing stations
On FM, you can store six stations on the
preset buttons 1-6 for each of the memory
banks I, II and T.
On MW/LW, you can also store six stations
each.
(only Bergamo RCR 148)
• Select the desired memory bank.
• Tune in a station with the rocker switch
(either automatically / or manually
<< >>).
• Press and hold down the desired pre-
set button until the radio resumes play
after the muting (takes approximately 1
sec., confirmed by beep).
Now the station has been stored.
The activated preset button is indicated in
the display.
Ber/Mon/WiRCR148 gb 08.05.2002, 11:42 Uhr 34