Banner SureCross DX81 - Manual

Delivers and manages dc voltage from one 3.6V dc lithium primary battery
• Wireless solution for powering a FlexPower™ Node and sensor device
• Unique power management system to run the FlexPower Node and a device through
switched power outputs for up to five years, depending upon the power requirements
of the device
• Replaceable 3.6V dc Lithium “D” cell battery
• IP67 sealed enclosure
FlexPower systems allow for a true wireless solution because the Node can be powered
by battery power (3.6 to 5.5V dc). Battery life is application specific. Contact Banner Engi-
neering’s application engineers for a battery life calculation for your specific application.
For additional information, the most recent version of all documentation, and a complete list of accessories, refer to Banner Engineering's
website,
www.bannerengineering.com/surecross .
Model Power Batteries Cable
DX81 3.6V dc battery One 3.6V Lithium "D" Cell 5-pin Euro pigtail QD
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious
injury or death. This device does NOT include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition.
5-pin Euro-Style Hookup for DX81
Only FlexPower® DX80 devices may be powered from this supply.
Wire No. Wire Color Description DX80...C Terminal Labels
1
2
3
4
5
3 Blue dc common (GND) V-
5 Gray 3.6V dc B+
Do not apply more than 5.5V dc to the gray wire.
DX81 and DX81H FlexPower Module Battery Replacement
For outside or high humidity environments, conductive grease may be applied to the battery terminals to prevent moisture and corrosion
buildup.
To replace the lithium "D" cell battery in the DX81 FlexPower™ battery kit, follow these steps.
SureCross DX81 FlexPower Supply Module
P/N 131596 Rev. E 11/13/2012
0 131596 7