Baldor MN903 - Manual

MN903
No. 275P Replaces 275N
LB7008
1 MN903
Instruction Manual For Baldor Grinders
SAFETY NOTICE:
WARNING statements describe conditions that may lead to personnel injury including potentially
fatal injuries if the machine is not properly used and warnings are not properly followed.
Caution statements describe conditions that may lead to equipment damage.
Electrical shock can cause serious or fatal injury. Only qualified personnel should install,
maintain or troubleshoot this equipment.
WARNING: Do not operate this grinder until you are sure that you are completely familiar with the safe
operation of the grinder, all accessories and safety equipment. Improper use can lead to
severe injury. This manual defines proper use of this equipment. Before using this
equipment for any other use, please consult Baldor. Contact Baldor if you do not
understand any procedure or operation concerning this grinder or this manual.
WARNING: Prevent electrical shock hazard and accidental machine operation. Always disconnect
grinder from the power source before servicing, changing accessories (such as wheels,
tool rest, spark arrestor, etc.) or before performing maintenance.
WARNING: Avoid accidental starting. Make sure switch is in “OFF” position before connecting to
power source.
WARNING: Be sure the system is properly grounded before applying power. Do not apply power
before you ensure that grounds are connected. Electrical shock can cause serious or fatal
injury. Follow the National Electrical Code (NEC) and local codes for the safe installation
of this equipment.
WARNING: Always use safety glasses with side shields (or full face shield) when operating grinder.
Do not use ordinary eyeglasses. Also use face or dust mask if cutting operation is dusty.
WARNING: Unsuitable accessories or attachments added to this machine can create hazards. Baldor
accessories are specifically designed to be used with this grinder. Use accessories or
attachments only in the proper intended manner. Accessories or attachments obtained
from another source may cause hazards. Consult the manufacturer before use.
WARNING: Keep guards in place and in working order. Guards are design to prevent injury. Never
operate this equipment if a guard is damaged, missing or improperly installed.
WARNING: Remove adjusting keys and wrenches from this product after use. Check to see that keys
and adjusting wrenches are removed from grinder before turning it on. Projectiles can
cause severe injury to yourself or others.
WARNING: Keep work area clean and well lighted. Clutter and poor lighting invites accidents.
WARNING: Don’t use in dangerous environment. Don’t use grinders in damp or wet locations, or
expose them to rain. Electrical shock can cause serious or fatal injury. Follow the
National Electrical Code (NEC) and local codes for the safe installation of this equipment.
WARNING: Do not wear loose clothing, neckties, rings, bracelets, or other jewelry to get caught in
moving parts. Nonslip footwear is recommended. Wear protective hair covering to contain
long hair.
WARNING: Don’t over reach. Keep proper footing and balance at all times. A rotating wheel or belt
can catch an article of clothing and cause personnel injury.
WARNING: Secure work. Use clamps to secure the work piece when practical. It’s safer than using
your hand and it keeps hands away from wheel.
WARNING: When starting a grinder for the first time, or after installing a replacement grinding wheel,
it is most important that the operator stand aside for at least one minute of rotation at full
speed. This is the correct practice since grinding wheels can disintegrate if they have
received damage during shipping or handling.
WARNING: Always have the grinder switch in the “OFF” position when changing the position of the
pivot arm. Do not attempt to change the pivot arm position while the belt is moving as this
will create a hazardous situation for the operator.