Bosch MUM 7000 UC - Manual (Page 15)

15
How to Use Blender
Either this plastic blender or the stainless
steel blender are available as accessory
items under the part numbers:
• MUZ 7 MX1
for blender with polycarbonate jar;
or
• MUZ 7 MX3
for blender with stainless steel jar.
The blender has been designed for crushing
ice; mixing liquids; pureeing vegetables;
preparing special diet and infant foods;
pulverizing fruit, vegetables, nuts and dried
bread (for bread crumbs); and preparing
mayonnaise and sauces.
Before beginning to use this or any other
attachment, make sure that the power unit
is on a clean, smooth, suitable work
surface and switched to off position, “O/Off,”
and that you have removed the motor drive
cover.
1. Before using the blender for the first
time, it is recommended that the
blender jar cover, closure/funnel and
blade/base assembly be washed. All
components, except the blade/base
assembly, are dishwasher safe.
Remove the blade/base assembly from
the blender, see figure 12.
CAUTION
Blade/base assembly is very sharp.
Handle with care.
The blade/base assembly may be
easily removed, as shown in figure 12a,
by inverting the blender and pressing
down on the quick release handle and
turning it counterclockwise until it
stops and then lifting up.
Blender with Unbreakable Plastic Jar
(MUZ 7 MX1)
WARNING
1. There is a risk of injury from sharp
blades when using the blender
attachment.
2. Keep hands and utensils out of the
blender jar while it is attached to the
power unit.
3. Blades are sharp. Handle carefully.
4. To avoid injury, never place blade
assembly on power unit without
blender jar properly attached.
5. Always operate the blender with the
cover in place.
6. The use of attachments, including
canning jars, not recommended by
the manufacturer, may cause a risk
of personal injury.
7. When blending hot and/or frothing
liquids, process a maximum of 18 fluid
ounces (0.5 litres) at a time.
The MUM 7100 UC, MUM 7150 UC and the
MUM 7220 UC Bosch Concept Series
Kitchen Machines include the MUZ 7 MX1
blender accessory. The blender accessory
consists of, figure 11:
Figure 11.
11a. Cover closure/funnel
11b. Cover
11c. Blender jar
11d. Blade/base assembly.