Brinkmann 844-0350-2 - Manual (Page 8)

6
• Wash glass globe with soapy water occasionally. Do not use abrasive materials.
• To protect your lantern, the unit must be kept clean and covered at all times when not in use.
• Only use replacement/accessory parts manufactured by The Brinkmann Corporation. Repairs should be
performed by The Brinkmann Corporation. For parts or repairs, contact The Brinkmann Corporation’s
Customer Service Department at 1-800-527-0717.
• Cover and store lantern in a protected area away from children and pets.
• After product has been stored and prior to reusing, verify that burners are free from leaves, insects, spider
webs, dirt, etc. as these items can obstruct the flow of combustion air.
• Prior to each use, visually check the burner/mantle for proper operation as described on page 5.
DO NOT use if burner/flame is not operating properly.
• This lantern requires an unobstructed airflow to operate correctly.
• During use or storage, always keep the lantern area clear and free of combustible materials, gasoline and
other flammable vapors and liquids.
NOTE: Due to the intense heat from burner, it is normal for discoloration to occur on lantern during the first
few uses.
PROPER CARE & MAINTENANCE
AFTER-USE SAFETY
• Always allow the lantern to cool completely before handling.
• When disconnecting propane cylinder, a small amount of LP gas is released until cylinder is completely
removed. Cylinder contains a self-sealing valve.
• Always disconnect the propane cylinder from lantern when not in use - replace plastic cap on the
propane cylinder.
• Store propane cylinder in a well ventilated area away from heat source or open flame.
Shutter Control
For directional lighting, slide lever over to
right to close shutter. For 360º lighting, slide lever over to
left to open shutter.
INS_844-0350-2_Lantern.qxd 1/5/05 4:55 PM Page 6