BT 100 - Manual (Page 3)

2
The ringer volume
switch is located on the
underside of your Decor
100 and effects the
volume at which your
phone rings.
There are two settings:
HI
A loud ring; your Decor
100 is preset to this
position.
LOW
A quiet ring.
Your Decor 100 is
now ready for use.
Using your
Decor 100
Lift the handset and
listen for a dialling tone.
Dial the number you
require.
To end the call, replace
the handset.
When the phone rings
pick up the handset and
speak.
Lift the handset.
Press the
REDIAL button.
The phone will
automatically dial the last
number dialled.
Your Decor 100 has 10
‘two-touch’ memory
locations, which are
dialled by using the
QUICKDIAL button.
Warning
Your Decor 100 is only
designed to be operated in
a normal office or
domestic environment.
It should not be used in
bathrooms or near water.
HI
LO
Redial
Quickdial
1
2
1
1
Installing
your Decor
100
Situate your Decor 100
close enough to a phone
socket so that the cables
will reach.
Do not stand it on carpets
or other similar surfaces
that generate fibres.
Do not cover or enclose
the machine; allow a free
flow of air to its surfaces.
Your Decor 100 can be
wall-mounted. See ‘Wall-
mounting’.
If you do not have a
modern style socket, call
Free
fone 0800 800 150
and ask for a BT
engineer to come and fit
the correct socket. This
is a chargeable service.
1 Situating your
Decor 100
2 Check your telephone
wall socket
3 Plug your Decor 100
into the telephone wall
socket
4 Set the ringer
volume
To make a call
To receive a call
To redial the last
number dialled
To store phone
numbers in the
Quickdial memory