Pioneer AVH-P5700DVD - Manual (Page 5)

English
Español
Deutsch
Français
Italiano
Nederlands
Fig. 2
4
ENG/MASTER 96 INST
5
Antenna cable
15cm
Parking brake
switch
Power supply side
Ground side
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of the parking
brake switch.
Yellow/black
If you use a cellular telephone, connect it via the
Audio Mute lead on the cellular telephone. If not,
keep the Audio Mute lead free of any connections.
Blue/white (7*)
To Auto-antenna relay control terminal
(max. 300 mA 12 V DC). Blue/white (6*)
Blue/white
To system control terminal of the power amp
(max. 300 mA 12 V DC).
The pin position of the ISO connector will differ
depending on the type of vehicle. Connect 6* and
7* when Pin 5 is an antenna control type. In
another type of vehicle, never connect 6* and 7*.
Note:
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner’s Manual or dealer.
Connection method
Clamp the lead. 1. 2. Clamp firmly ff with
needle-nosed
pliers.
Violet/white
Of the two lead wires connected to the back lamp,
connect the one in which the voltage changes when
the gear shift is in the REVERSE (R) position.
For details, refer to Fig.4