Pioneer FH-P4100R - Manual (Page 47)

Black plate (47,1)
47 CRD3576-A
! Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 44).
! Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
1 Press FUNCTION to select REAR SP.
Press FUNCTION repeatedly until REAR SP ap-
pears in the display.
2 Select full-range speaker or
subwoofer with c/d.
Pressing c/d will switch between
REAR SP:FUL (full-range speaker) and
REAR SP:S/W (subwoofer) and that status will
be displayed.
Selecting the digital
attenuator
When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting so
this setting is usually used.
1 Press FUNCTION to select DIG.ATT.
Press FUNCTION repeatedly until DIG.ATT ap-
pears in the display.
2 Select DIG.ATT high or low with c/
d.
Pressing c/d will switch between DIG.ATT: H
(high) and DIG.ATT: L (low) and that status
will be displayed.
Adjusting display contrast
Display contrast adjustment lets you adjust
the display for easier viewing when lighting
conditions change.
1 Press FUNCTION to select
CONTRAST.
Press FUNCTION repeatedly until CONTRAST
appears in the display.
2 Press c or d to adjust the contrast.
Each press of c or d increases or decreases
the contrast.
+7 7 is displayed as the contrast is in-
creased or decreased.
Initial Settings 11
En
47
English
Section