Pioneer RS-A9 - Manual (Page 69)

Installation
CAUTION
• Do not install in:
—Places where it could injure the driver or passengers if the vehicle stops suddenly.
—Places where it may interfere with the driver, such as on the floor in front of the driver’s seat.
• Make sure that wires are not caught in the sliding mechanism of the seats, resulting in a short-circuit.
• Confirm that no parts are behind the panel when drilling a hole for installation of the amplifier. Protect all
cables and important equipment such as fuel lines, brake lines and electrical wiring from damage.
• Install tapping screws in such a way that the screw tip does not touch any wire. This is important to prevent
wires from being cut by vibration of the car, which can result in fire.
• To prevent electric shock, do not install the amplifier in places where it might come in contact with liquids.
• To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the sup-
plied ones are used, they may damage internal parts of the amplifier, or they may become loose causing the
amplifier to shut down.
To prevent malfunction
• To ensure proper heat dissipation of the amplifier, be sure of the following during installation.
—Allow adequate space above the amplifier for proper ventilation.
—Do not cover the amplifier with a floor mat or carpet.
• Do not install the amplifier near a door where it may get wet.
• Do not install the amplifier on unstable places such as the spare tire board.
• The best location for installation differs with the car model and installation location. Secure the amplifier at
a sufficiently rigid location.
• Make temporary connections first and check that the amplifier and the system operate properly.
• After installing the amplifier, confirm that the spare tire, jack and tools can be easily removed.
68
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS