beautypg.com

Environment concerns – AEG HC652600EB User Manual

Page 29

background image

Problem

Possible cause and remedy

The heat setting changes be-

tween two levels.

The Power management is activated. See the section Power man-

agement.

The sensor fields become hot.

The cookware is too large or you out it too near to the controls.

Put large cookware on the rear cooking zones if it is necessary.

There is no signal when you

touch the panel sensor fields.

The signals are deactivated. Activate the signals (see OffSound

Control).

comes on

The Automatic Switch Off operates. Deactivate the cooking zone

and activate it again after 60 seconds.
If after 60 seconds comes on again speak to the service cen-

tre.

comes on

• No cookware on the cooking zone. Put cookware on the cook-

ing zone.

• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for

the cooking zone. Move cookware to a smaller cooking zone.

and number comes on.

There is an error in the appliance.

Disconnect the appliance from the electrical supply for some

time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the service centre.

comes on

There is an error in the appliance, because a cookware boils dry.

The protection against become too hot for the cooking zone op-

erates. The Automatic Switch Off operates.

Deactivate the appliance. Remove the hot cookware. After, ap-
proximately 30 seconds activate the cooking zone again.

should go out of the display, residual heat indicator can stay. Let

the cookware become sufficiently cool and check it with the sec-

tion Cookware for the induction cooking zone.

If you tried the above solutions and cannot repair the problem, speak to your dealer or the

customer service. Give the data from the rating plate, three digit letter, code for the glass

ceramic (it is in the corner of the glass surface) and an error message that comes on.

Make sure, you operated the appliance correctly. If not the servicing by a customer service

technician or dealer will not be free of charge, also during the warranty period. The instruc-

tions about the customer service and conditions of guarantee are in the guarantee booklet.

ENVIRONMENT CONCERNS

The symbol on the product or on its packaging indicates that this product may not be

treated as household waste. Instead it should be taken to the appropriate collection point

for the recycling of electrical and electronic equipment. By ensuring this product is

disposed of correctly, you will help prevent potential negative consequences for the

environment and human health, which could otherwise be caused by inappropriate waste

handling of this product. For more detailed information about recycling of this product,

Environment concerns

29