Arctic Cat MONSTER TRACTION P8814 User Manual

Page 11

P8814pr-0920

• First, insert a screw through each side of the vehicle and into

the ends of the windshield/dashboard. Tighten the screws.

• Next, insert two screws through the inside of the vehicle and

into the windshield/dashboard. Tighten the screws.

• Using safety scissors, carefully cut the plastic tie holding the

shovel and clip together.

Note to Retailer: Do not cut the plastic tie. The plastic tie holds
the shovel in place for display purposes.
• Place the clip and shovel assembly onto the hood.
• First, slide a washer onto the remaining screws. Then, insert

the four screws with washers through the underside of the
hood and into the clip. Tighten the screws.

• Lift and lower the hood closed.
• Pull the hood strap down and over the button on each side of

the front end of the vehicle.

DASH VIEW

Clip

Shovel

Hood

Screws

FRONT VIEW

SIDE VIEW

Screws

Washers

Button

Hood Strap

• Insert four screws through the dashboard and into the front

end of the vehicle. Tighten the screws with a

short shaft

Phillips screwdriver.

Screws

Dashboard

FRONT VIEW