ATTO Technology FCSW - Manual (Page 14)

i ATTO Technology ExpressPCI FCSW and FC 2600 Installation and Operation Manual
Appendix A Standards and compliances
The equipment described in this manual generates and uses radio frequency energy. The Technical
Specification sheet for a particular ATTO ExpressPCI host bus adapter list certifications for that model.
FCC Standards: Radio and Television Interference
______
WARNING This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Y
Reorient or relocate the receiving antenna
Y
Increase the separation between the equipment and receiver
Y
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Y
Consult the dealer or an experienced radio/TV technician for help
Canadian Standards
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numerique to la Classe B est conforme a la norme NMB-003 du Canada.
European Standards
Declaration of Conformity
This following statement applies to the ATTO Express PCI host bus adapter.
This device has been tested in the basic operating configuration and found to be compliant with the
following European Union standards:
Application of Council Directive: 89/336/EEC
Standard(s) to which conformity is declared: EN55024:1998
This Declaration will only be valid when this product is used in conjunction with other CE approved
devices and when the entire system is tested to the applicable CE standards and found to be compliant.
Usage Restrictions
The use of optical instruments with this product will increase eye hazard.
The multimode transceiver (ATTO Express PCI FCSW only) is a Class 1 laser product complying with
IEC 825-1 and FDA-21 CFR 1040.11. To meet laser safety requirements, the transceiver shall be
operated within the maximum ratings. The laser is non-OFC compliant as it is a Class 1 device.
The optical ports of the modules must be terminated with an optical connector or with a dust plug.
Failure to adhere to the above restrictions could result in a modification that is considered an act of
“manufacturing” and will require, under law, recertification of the modified product with the U.S. Food
and Drug Administration (ref. 21 CFR 1040.10(i)).