AZEK Stair Rail with Universal Bracket - Manual (Page 4)

14 Cut
Post
Sleeves
Cutting the Handrail
slightly longer than the
Top Retainer will provide
a tighter fit and more
accurate appearance
Tip
19
Measure & Cut Handrail
Remove
Universal
Brackets
from Rail
Section
X 5
Attach
Handrail
to Top
Retainer
20
Rail assembly
from step
10
Do not over torque screws
when fastening Bracket to
Posts as this may cause
Post Sleeves to crack.
Important:
16 Attach
Universal
Bracket
Assemblies to
Posts
Loosen lag
screw
slightly to
allow
movement
when
installing rail
section
Lag
Screw
Ball
Cup
Bracket
15
Leave the
threaded plates
installed on
Bottom Rail.
Tip
X 8
18 Tighten Universal
Brackets 17 Attach Rail
Section to Posts
Rail assembly
from step
15
X 8
X 2
Cut Post Sleeve
minimum 2” longer
than desired railing
height.
IMPORTANT
Make sure that the
DRIVE TOOL/DRILL
is configured or set
to use the SCREW
setting when driving
and/or tightening all
FASTENERS.
STAIR RAILING WITH UNIVERSAL BRACKET INSTALLATION GUIDELINES for
AZEK Premier AZEK Trademark AZEK Reserve
Page 4
© 2013 AZEK Building Products. All rights reserved