AZEK Porch EN - Manual (Page 6)

Page 6
3
2
INSTALLING THE NEXT BOARD
• Install the next board by inserting the grooved edge over the exposed
tongue on the starting board. It may be necessary to apply light pres-
sure to ensure the board is engaged completely to minimize irregularity
in top seam.
• After board is fully engaged onto the starting board, drive fasteners
through the tongue at each joist as shown in Diagram 2. Remember to
countersink the fasteners slightly to provide necessary clearance when
installing the next board.
Starting
Plank
INSTALLING THE REMAINING BOARDS
• Continue to add boards per step 2 until outer edge of porch is
reached.
• Final board may require removal of tongue or rip cutting to a
necessary width. Use a table saw or circular saw to accomplish this.
Attach the last board by face fastening through the top or toe fasten
along the outer edge.
Diagram 2
Installation Instructions