Pulsafeeder PulsaPro 900 EN - Manual (Page 69)

68
1. Scope of Supply
This addendum covers the installation of a Rotork series IQ controller supplied with PulsaPro 900 series pump.
This mounting installation information is not covered in the Rotork IQ Installation and Maintenance Instruction
manual E170E3.
2. General Safety
This controller assembly was designed for operation solely with the Pulsafeeder PulsaPro 900 pump. Using this
unit for any other application or on any other piece of equipment is considered un-safe and voids all certification
markings and warranties.
2.1 Explosive Atmosphere Safety
Explosion Hazard -- Do not perform installation or maintenance of any kind on this device while circuit
is live and/or the area is known to be hazardous.
2.2 Electrical Safety
Improper application and use of the switch assembly can be hazardous. You are solely responsible for its use.
The electrical installation must conform to all relevant electrical codes. Installation and electrical
maintenance must be performed by a qualified electrician. Before installing or servicing this device please
refer to Rotork IOM E170E3 which can be found in the pump document packet or at
www.rotork.com .
2.3 Hydraulic Safety
Thoroughly review and adhere to the contents of the latest version of the PulsaPro 900 Installation, Operation,
and Maintenance (IOM) manual for hydraulic installation of your PulsaPro 900 metering pump.
3. Mounting of Pump Controller
During assembly of the stroke control unit to pump, NO adjustment should be made to the stroke
controller or pump input shaft…Doing so will alter the zero point of the pump and will cause damage
upon startup.
The Stroke Control unit comes from the factory with preset parameters for limits of zero and one hundred
percent stroke settings. These parameters must not be alerted in any way or damage will occur to the stroke
adjust components.
Refer to the Rotork IOM before any additional programming is done.