Pitco Frialator HERITAGE I12 - Manual (Page 2)

Heritage I12 Computer, Single Vat (PP11370) and Dual Vat (PP11372)
Quick Reference Card
L20-320 Rev 0 10/07
F
u
n
c
ti
o
n
K
e
y
s
P
r
o
g
r
a
m
m
in
g
FIRST LEVEL PROGRAMMING
ENTER PROGRAM Press key, display show [PROGRAM], If PASSWORD IS REQUIRED, and you are unable
to remember the set password use (6684).
SET TEMPERATURE Single or Dual Vat (left side ) - Press Enter Desired Temperature.
Dual Vat (right side) - Press Enter Desired Temperature.
To SAVE and CONTINUE Press , to EXIT First Level Programming Press Again.
SET TIME(s) .. Press , display shows [SELECT] [PRODUCT] ,Press any Product Key [L,1,2,3,4,5,6,7,8,9,0,R].
COOK TIME (CKn mm:ss] Enter Time and Press to proceed to SHAKE TIME (SHn mm:ss] Enter Time and
Press to proceed to HOLD TIME (HDn mm:ss] Enter Time and Press to proceed to HOLD PRE-ALARM
(PAn mm:ss] Enter Time and Press to return to [SELECT] [TIME] , repeat for other product keys.
To SAVE and CONTINUE Press , to EXIT First Level Programming Press Again.
SECOND LEVEL PROGRAMMING
ENTER PROGRAM Press key, display shows [PROGRAM], If PASSWORD IS REQUIRED, and you are
unable to remember the set password use (6684). Then press you have now entered the upper level programming,
all the useable function keys will be lighted and the display will show [SELECT OPTIONS].
NOTE: Any time is used to save a setting, must be pressed to return to [SELECT OPTIONS].
FAHRENHEIT / CELCIUS – Toggle between Fahrenheit and Celcius scale by pressing the key
Change is saved by pressing the key to set
SET PASSWORD – Press to choose [PASS REQ] or [NO PASS]. If password is chosen then
press , current password displays. Use the number keys to enter new password and press to set.
BEEPER VOLUME & TONE – Press to toggle between levels 1,2,3 & Tone(1,2,3) and press to set.
LANGUAGE – Press to toggle between different languages and press to set.
MELT CYCLE – Press to toggle [NO MELT], [SOLID], or [LIQUID] and press to set.
RECOVERY TIME – Press to display [F065 LXXX], “F” is Factory time and lastest time is “LXXX”
CONTROL/TIMER (Single or Dual-left side) – Press to switch control to timer mode,press to set.
CONTROL/ TIMER (Dual Tank-right side) – Press to switch control to timer mode , press to set.
To SAVE and CONTINUE Press , to EXIT SECOND Level Programming Press Again.
OTHER DISPLAYS:
[PROBE OP] [OPEN] If probe is detected open, normal heating and cooking activities are suspended.
[HIGH TMP] [HIGH TMP] If vat temperature has exceeded set temperature by 40°F (22°C), or an absolute of 410°F (210°C) max.
[DRAINING] [TURN OFF] Drain valve has been opened, Heat control is turned off. To restore to normal operation, close the drain
valve. Display will show [TURN OFF] [TURN OFF]. Turn controller off, and refill the vat.
[HEAT] [FAILURE] OR [IGNITION] [FAILURE] Heating system failed to respond due to a tripped high temperature limit switch and
is in need of resetting. For gas models, the pilot failed to light, flame ignition detection is marginal or draft protector tripped on SCB.
[SYSTEM] [FAILURE] If probe is detected as a short circuit, normal heating and cooking activities are suspended.