Agilent Technologies HSSI WanProbe J3916A - Manual (Page 45)

Local Terminal Configuration
Using the Main Menu
25
Allow Packet Press 3 and then type Yes to allow or No to not allow
Generation packet generation.
Allow duplicate and Press 4 and then type Yes to allow or No to not allow
changed IP checking checking of duplicate and changed IP addresses.
3. Press S to save your changes and return to the Main Menu.
4. Press 0 to cancel your current changes and return to the Main Menu.
Modify/View Interface Values
Use the Modify/View interface Values menu to configure the probe port interface
settings. This procedure involves two steps—selecting the port and then setting
the configuration. For example, the options for the port configuration are:
z [1] 1.1/Ethernet
z [2] 1.2/Serial
z [3] 3.1/Frame_Relay
z [4] 3.1/HSSI
NOTE Refer to “Display Interface Summary” on page 36 for information on port types
and port numbers for the installed interfaces.
NOTE Port 1 is always the Ethernet telemetry interface (the 10Base-T/100Base-TX with
RJ-45 and AUI connectors).
Fast Ethernet Telemetry Interface Configuration
Use the following procedure to configure the Fast Ethernet Telemetry Interface:
1. On the Main Menu, Press 3 , Modify/View interface values. You see the
Modify/View Interface Values menu (Figure 2-5).