Antec SOLO II - Manual (Page 10)

10
2.2 M OTHERBOARD I NSTALLATION
Before proceeding:
Check the manual for your CPU cooler to find out if there are steps you must do before installing the
motherboard.
Make sure you have the correct I/O panel for your motherboard. If the panel provided with the
chassis isn’t suitable, please contact your motherboard manufacturer for the correct I/O panel.
The SOLO II comes with four preinstalled motherboard standoffs. These are positioned for Standard
ATX motherboards but can be relocated to accommodate other form factors.
1. Align the motherboard with the standoff holes on the motherboard tray and remember or mark
which holes are lined up
2. Install standoffs as needed and put the motherboard in. The motherboard tray has indicators
pertaining to specific form factors. Use the holes marked “A” for Standard ATX and the holes
marked “M” for microATX.
Caution: Make sure to remove any unused motherboard standoffs. They may come into contact with
the back of the motherboard and may electrify your chassis exterior if left connected.
Make sure you have the correct I/O panel.