Audio-Technica ATW-U102 - Manual (Page 8)

8
Specifications †
Optional Microphones and Cables
Overall System
UHF Operating Frequency
“x” systems 656.125-668.500 MHz
non-”x” systems 728.125-740.500 MHz
Number of Channels 100 total
Frequency Stability ±0.005%, Phase Lock Loop frequency
control
Modulation Mode FM
Normal Deviation ±10 kHz
Operating Range 300' typical (ATW-U102: 200' typical)
Operating Temperature Range 41° F (5° C) to 113° F (45° C)
Frequency Response 100 Hz to 15 kHz
ATW-R100(x) Receiver
Receiving System Dual independent receivers, automatic
switching diversity
Image Rejection 35 dB nominal
Signal-to-Noise Ratio 107 dB at 30 kHz deviation
(IEC-weighted), maximum modulation
75 kHz
Total Harmonic Distortion <1% (10 kHz deviation at 1 kHz)
Sensitivity 26 dB ␮V, (S/N 60 dB at 5 kHz deviation,
IEC-weighted)
Intermediate Frequency 45 MHz, 10.7 MHz
Audio Output (balanced) 31.6 mV (at 1 kHz, ±5 kHz deviation, 10k
ohm load)
Output Connector 3-pin XLRM-type
Monitor Headphone Output 75 mW max. at 1 kHz, 1% T.H.D.,
(typical) into 32 ohm (each channel) stereo
headphones
Monitor Headphone Jack 3.5 mm TRS, signal on both Tip and Ring
External Power Requirements 12V DC nominal, 200 mA
Batteries Two 9V (NEDA type 1604) alkaline, not
included
Current Consumption 130 mA typical
Battery Life Approximately 5-7 hours (depending on
battery type and use pattern)
Dimensions 3.35" (85.0 mm) W x 4.53" ( 115.0 mm) H
x 1.42" (36.0 mm) D
Net Weight (without batteries) 12.0 oz (340 grams)
Accessories Included Two flexible UHF antennas; control
screwdriver; mounting pouch; hook &
loop fasteners
AT831cT5 Miniature cardioid condenser microphone, terminated with a
TA5F connector for use with the ATW-T101(x) transmitter. Includes clothing
clip and windscreen.
MT830cT5 Subminiature omnidirectional condenser microphone, terminat-
ed with a TA5F connector for use with the ATW-T101(x) transmitter.
Includes clothing clip and windscreens.
MT830cT5-TH “Theater” model, same at MT830cT5 except beige color
mic and cable for concealment.
AT8340 Input cable connects mics with 3-pin XLRM-type output to
ATW-T101(x) body-pack transmitter. 4.3' (1.3 m), XLRF to TA5F connectors.
AT8341 Output cable connects ATW-R100(x) receiver to camera or other
device. 19" (0.5 m), XLRF to right-angle 3.5 mm stereo mini-plug.
ATW-T101(x) Body-pack Transmitter
RF Power Output
10 mW typical
Spurious Emissions Under federal regulations
Input Connector TB5M
Line Input Impedance/Level 100k ohms/3.16V max. input at 1 kHz,
1% T.H.D.
Battery 9V (NEDA type 1604) alkaline,
not included
Current Consumption 50 mA typical
Battery Life Approximately 7-9 hours (depending on
battery type and use pattern)
Dimensions 2.52" (64.0 mm) W x 3.78" (96.0 mm) H
x 0.91" (23.0 mm) D
Net Weight (without battery) 5.0 oz (143 grams)
Accessory Included Control screwdriver
ATW-T102(x) Plug-on Transmitter
RF Power Output
10 mW typical
Spurious Emissions Under federal regulations
Input Connector 3-pin XLRF-type
Battery 9V (NEDA type 1604) alkaline,
not included
Current Consumption 60 mA typical
Battery Life Approximately 7-9 hours (depending on
battery type and use pattern)
Dimensions 1.58" (40.0 mm) W x 4.32" (109.8 mm) H
x 1.58" (40.0 mm) D
Net Weight (without battery) 6.2 oz (177 grams)
† In the interest of standards development, A.T.U.S. offers full details on its test methods
to other industry professionals on request.
For future reference, please record your system information here.
Receiver ATW-R100 Serial Number
ATW-R100x Serial Number
Transmitter ATW-T101 Serial Number
ATW-T101x Serial Number
ATW-T102 Serial Number
ATW-T102x Serial Number