Sony KLV-23M1 - Manual (Page 31)

31
Connecting and Setting the TV
VHF/UHF
VIDEO IN
VIDEO
1
S VIDEO
(MONO
) A
UDIO
R
L
S VIDEO cable
(not supplied)
DVD Player
A/V cable
(not supplied)
Rear of TV
S VIDEO
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
Connecting a DVD Player with S Video and Audio
Connectors
Use this hookup if:
• Your DVD player does not have component (Y, P
B
, P
R
) jacks.
Tips
• If your DVD player has component video output connectors, for best picture quality, use the
connection described on page 30.
• The Y, P B and P R jacks on your DVD player are sometimes labeled as Y, C B and C R , or Y,
B-Y and R-Y. If so, connect the cables to the matching colors.
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to
16:9 on your DVD player. For details, refer to the operating instructions supplied with your
DVD player.
Disconnect all power sources before making any connections.
1
Using an A/V cable, connect the DVD player’s AUDIO OUT jacks to the
TV’s AUDIO IN jacks.
2
Using an S VIDEO cable, connect the DVD player’s S VIDEO OUT jack
to the TV’s S VIDEO IN jack (VIDEO 1 IN or VIDEO 2 IN).
Tip
If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
“Auto YC” in the
(Setup) menu is set to “On” to view the S VIDEO input (see page 26).
Tip
Use VIDEO 1/2 on the remote control to switch to the DVD player input.