Sony D-E565 User Manual
Playing a cd right away, Compact disc compact player, Play
![background image](/manuals/443383/1/background.png)
Play
Compact Disc
Compact Player
Playing a CD right
away!
If you want to play a CD right now, choose to use your player on house
current. Other choices are the following three: rechargeable batteries,
dry batteries (see “Power Sources” on the reverse side) and car battery.
Connect
Sony Corporation ©1999 Printed in Malaysia
3
1
For the customers in the USA
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
For the customers in Australia
The supply cord of the AC power adaptor cannot
be replaced; if the cord is damaged, the AC
power adaptor should be discarded.
For the customers not in Europe
The CE mark on the unit is valid
only for products marketed in the
European Union.
to a wall
outlet
AC power adaptor
DC IN 4.5 V
1
Slide OPEN to open the lid.
OPEN
Welcome!
Thank you for purchasing the Sony
Compact Disc Compact Player.
Before operating your player, please
read this manual and retain it for
future reference.
About this manual
The instructions in this manual are for the
D-E561 and D-E565. Before you start reading,
check your model number.
Owner’s Record
The model and the serial numbers are located at
the bottom. Record these numbers in the spaces
provided below. Refer to them whenever you
call upon your Sony dealer regarding this
product.
Model No. __________ Serial No.__________
WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
To avoid electrical
shock, do not open the
cabinet. Refer servicing
to qualified personnel
only.
CAUTION
The use of optical instruments with this product
will increase eye hazard.
2/REMOTE
For models supplied with the remote control
• Connect the plug of the headphones to the remote control.
• Connect the headphones to the remote control firmly. A loose connection may cause noise
during playback.
Place a CD
2
2
Adjust the volume.
1
Press
^.
To stop play, press
p.
To use the remote control
1
Press
(.
2
Adjust the volume.
Operating Instructions
About area code
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
For accessories supplied with your player, check the area code of your model
and refer to “Supplied accessories” toward the end of this manual.
3-867-524-11 (1)
D-E561
D-E565
z
Other Operations
Playing tracks repeatedly
(Repeat Play)
You can play tracks repeatedly in normal,
INTRO PGM, shuffle or RMS (Random Music
Sensor) play modes. Repeat all the tracks,
only one track or the specified part within the
same track.
To repeat all the tracks
Press REPEAT/ENTER during play.
The “
” indication appears.
To cancel repeat play, press REPEAT/ENTER
again.
To repeat a single track
1 Press REPEAT/ENTER while the track you
want to repeat is playing.
The “
” indication appears.
2 Press PLAY MODE repeatedly until “1”
appears.
To repeat another track, press
= or + .
To cancel repeat play, press REPEAT/ENTER
again.
To repeat the specified part within
the same track (LOOP Play)
1 During play, press PLAY MODE
repeatedly until “A˜B” flashes in the
display.
2 Press REPEAT/ENTER to set the point
(point A) where you want to start repeat
play.
Point A is stored in the memory.
3 Press REPEAT/ENTER again to set the
point (point B) where you want to stop
repeat play.
Point B is stored in the memory, and repeat
play starts from point A.
To change points A and B, press and hold
REPEAT/ENTER until “A˜B” flashes in the
display, then do steps 2 and 3 again.
To set points A and B on other tracks, press
= or + to select another track, then do
steps 2 and 3 again.
If you press
p, the stored points will be
erased. To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
To cancel repeat play, press PLAY MODE
until “A˜B” disappears from the display.
2
Press
= or + to choose a track.
The track number and the playing order
appear.
3
Press REPEAT/ENTER to program the
track.
4
Repeat steps 2 and 3 to program the
remaining tracks.
5
Press ^ .
“RMS” stops flashing and the tracks you
have chosen play in the order you
specified.
If you press
p, the program will be erased. To
prevent accidental erasure, set the RESUME
switch at the rear of the player to ON.
To cancel RMS play, press PLAY MODE until
“RMS” disappears from the display.
To check the program
During programming:
Press REPEAT/ENTER before step 5.
During RMS play:
Press PLAY MODE repeatedly until
“RMS” flashes, then press REPEAT/
ENTER.
Each time you press REPEAT/ENTER, the
track number and the playing order appear in
the order you specified.
Note
• If you program another track after the 22nd
track, the first track programed is cleared and
the new track is programed instead.
Using other functions
To minimize skipping (ESP
2
)
The ESP (Electronic Shock Protection)
function minimize skipping by using a buffer
memory that stores music data and plays it
back in the event of a shock.
The new ESP
2
(ESP Squared) system uses a
new DSP (Digital Signal Processor) which can
read and store music data more efficiently,
providing a level of continuous skip
protection not found in traditional buffer
memory units. This decreases the frequency
of sound skipping and the need to utilize the
buffer memory. Use this function when
listening in a car or while walking.*
* Although ESP
2
provides excellent protection
against skipping, it will not prevent skipping
while jogging or running.
Press ESP.
The ESP indication appears.
To release the ESP function, press ESP again.
Notes
• Playing may stop when the player gets a strong
shock even with the ESP function on.
• You may hear a noise or sound skip when:
— listening to a dirty or scratched CD,
— listening to an audio test CD or,
— the player receives continuous shock.
• Sound may drop for a while if you press ESP
during play.
• When you use an optical digital connecting
cord, the ESP function will be disabled.
To enjoy more powerful bass sound
(Sound function)
You can enjoy a powerful bass-boosted sound.
Press SOUND to select “MB (Mega Bass)” or
“GRV (Groove).” “GRV” is more effective.
Note
• If the sound is distorted when emphasizing
bass, turn down the volume.
Playing only the tracks
you want
(INTRO PGM Play)
You can choose and play your favorite tracks
by scanning through the beginning of each
track in a CD.
1
During play, press PLAY MODE
repeatedly until “INTRO PGM” flashes.
2
Press
^ to start scanning.
The player plays about the first 15
seconds of each track and “INTRO PGM”
flashes faster.
3
Press REPEAT/ENTER while the track
you want is playing. To skip the track,
press
+ or just wait for the next track.
After you have gone through the CD,
“INTRO PGM” stops flashing and the tracks
you have chosen play automatically.
To finish programing before going through
the whole CD, press
^. The selected tracks
will be played.
If you press
p, the program will be erased.
To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
To cancel INTRO PGM play, press PLAY
MODE repeatedly until the play mode
indication disappears from the display.
Playing tracks in random
order
(Shuffle Play)
You can play the tracks in a CD in random
order.
During play, press PLAY MODE repeatedly
until “SHUF” appears.
The tracks play in random order.
To cancel shuffle play, press PLAY MODE
repeatedly until the play mode indication
disappears from the display.
Note
• During shuffle play, you cannot return to
previous tracks by pressing
= .
Playing tracks in the order
you want
(RMS play)
You can program up to 22 tracks to play in
any order you choose.
1
During play, press PLAY MODE
repeatedly until “RMS*” flashes.
*RMS = Random Music Sensor
Flashing
Flashing
Playing order
Track number Flashing
Not these ways
*AMS = Automatic Music Sensor
**These operations are possible during both
play and pause.
If you press REPEAT/ENTER on the player to
display “
”, you can locate the tracks
continuously in the following order:
• When using
+: next track n next track
...... last track n first track n second track
......
• When using
=: previous track n
previous track ...... first track n last track
......
To remove the CD
Remove the CD while pressing the pivot.
Notes on controlling the volume with
the remote control
Set the VOL (volume) control on the remote
control to the maximum. Then adjust the
volume on the player to the level that you
want to be the maximum volume of the
remote control.
Notes on display
• When you press
^ or ( (when RESUME
is set to OFF), the total number of tracks in
the CD and the total playing time appear for
about 2 seconds.
• During play, the track number and the
elapsed playing time of the current track
appear.
• During pause, the elapsed playing time
flashes in the display.
• Between tracks, the time to the beginning of
the next track will appear with the “–”
indication.
Notes on handling CDs
• To keep the CD clean, handle it by its edge.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
To
Pause (main unit
only)
Resume play after
pause (main unit
only)
Find the beginning
of the current track
(AMS*)
Find the beginning
of previous tracks
(AMS)
Find the beginning
of the next track
(AMS)
Find the beginning
of succeeding tracks
(AMS)
Go forward quickly
Go backwards
quickly
Headphones
PLAY MODE
=/+
REPEAT/
ENTER
PLAY MODE
+
REPEAT/
ENTER
^
PLAY MODE
^
=/+
ESP
Label side up
2
Fit the CD to the pivot.
3
Close the lid.
PLAY MODE
REPEAT/
ENTER
Press
^
^
= once**
= repeatedly**
+ once**
+ repeatedly**
Hold down
+**
Hold down
=.**
Flashing
Flashing
Light up
Light up
SOUND
Continue to the reverse side m