0 installation – APC 2000XL User Manual
Page 15
Page 13
4.0 Installation
4.1 Receiving inspection
Once the UPS has been removed from its shipping container, it should be inspected for
damage that may have occurred while in transit. Immediately notify the carrier and
place of purchase if any damage is found. The packing materials are made from
recyclable materials and should be saved for reuse or disposed of properly.
4.2 Placement
The UPS may be installed in any protected environment. The location should provide
adequate air flow around the unit, in an atmosphere free from excessive dust. Do not
operate the UPS in an environment where the ambient temperature or humidity is
outside the limits given in the Specifications section of this manual.
4.3 Install bracket - 2000VA models, 220/230/240 Vac version
The 220/230/240 Vac version 2000VA model UPS is supplied with a bracket that serves
to stabilize the UPS and Battery packs (other models and versions do not require this
bracket). To install the bracket, follow the instructions listed below.
4.3.1
Position the UPS and Battery pack enclosures as shown in the illustration below and
remove the enclosure screws indicated.
4.3.2
Place bracket between the UPS and Battery pack and attach using the supplied
screws.