Sony DHC-FL7D - Manual (Page 47)

47 GB
Tape
7
Press CD SYNC HI-DUB.
“ ” flashes, and “SYNC” appears in the
display.
8
Press PLAY MODE/DIRECTION on the
remote repeatedly to select
g to
record on one side.
Select
j (or RELAY) to record on
both sides.
9
Press REC PAUSE/START.
Recording starts.
To cancel Program Edit in stop mode
Press PLAY MODE/DIRECTION on the
remote repeatedly until “1 DISC” or “ALL
DISCS” appears in the display.
Timer-recording radio
programs
To timer-record, you must set the clock (see
“Setting the clock” on page 16) and preset the
radio stations (see “Presetting radio stations”
on page 41) beforehand.
1
Tune in the preset radio station (see
“Listening to the radio” on page 42).
2
Press CLOCK/TIMER SET on the
remote.
“DAILY SET?” appears.
3
Press . or > repeatedly to select
“REC SET?”, then press ENTER on the
remote.
“ON” appears and the hour indication
flashes.
4
Set the time to start recording.
Press . or > repeatedly to set the
hour, then press ENTER on the remote.
The minute indication flashes.
Press . or > repeatedly to set the
minutes, then press ENTER on the remote.
The hour indication flashes again.
5
Set the time to stop recording following
step 4.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., “TUNER FM 5”), then the original
display appears.
6
Insert a recordable tape into deck B.
7
Turn off the power.
When the recording starts, the volume level
is set to the minimum.
To
Check the setting
Change the setting
Cancel the
Timer-recording
Notes
• If the power is on at the preset time, the Timer-
recording does not work.
• When you use the Sleep Timer, the Timer-recording
will not turn on the system until the Sleep Timer
turns it off.
• The power turns on 15 seconds before the preset
time.
• You cannot activate the Daily timer and the Timer-
recording simultaneously.
Do this
Press CLOCK/TIMER
SELECT on the remote and
press . or > repeatedly
to select “REC SELECT?”,
then press ENTER on the
remote.
Start over from step 1.
Press CLOCK/TIMER
SELECT on the remote and
press . or > repeatedly
to select “TIMER OFF?”,
then press ENTER on the
remote.