Airlink RT210W - Manual (Page 3)

Accessing the Web-Based Configuration Utility
4
Step 1 Start your Web browser and type http://192.168.1.1 in the URL field.
This is your router's default private IP address.
Step 2 After connecting to the device,
you will be prompted to enter the
username and password. Leave the
username empty and enter the default
password as
admin.
Step 3 The Web-Based utility will appear with the System Overview table
selected.
5
Quick Configuration for Wireless Router
Click the WAN page link to configure the WAN interface.
W A N T y p e D e s c r i p t i o n
D H C P C lient If yo u a r e c o n n e c t i n g t h r o u g h D H C P o r a d y n a m i c
IP a d d r e s s f r o m y o u r IS P , k e e p this default setting.
P P P o E C lient If yo u a r e c o n n e c t i n g t h r o u g h P P P o E , c h e c k
P P P o E fro m the protocol listed. C o m p le te the User
n a m e a n d P a s s w o r d f i e ld s .
M a nual C o nfig If your IS P a s s i g n s y o u a s t a t i c IP a d d r e s s , c h e c k
M a n u a l C o n fig fro m p rotocol listed. C o m p le te the
IP a d d r e s s , S u b n e t m a s k , D e f a u l t G a t e w a y , a n d
D N S s e rve r fie ld s . Y o u n e e d t o e n t e r a t l e a s t o n e
D N S a d d r e s s .
P P T P C lient T h i s i s a s e r v i c e u s e d i n E u r o p e o n l y . If yo u a r e
u s i n g a P P T P c o n n e c t i o n , c h e c k w i t h y o u r IS P for
the n e c e s s a r y s e t u p i n f o r m a t i o n .
If you want to use the Router to share your Internet (DSL/Cable Modem)
connection, keep the
WAN/LAN Relation as NAT Routing selected.
There are four types of WAN connections ( protocols) as listed in the following
table. Your ISP will provide you with information and a description of your WAN
connection. The ISP may require a specific setting. Select the correct protocol
for your ISP from the table below. See the User Manual for more information.
After selecting the proper WAN connection setting, click Apply to register
these settings with the Router. After the settings have been registered, the
screen will return to the WAN page and the settings are effective.
Note that if you use the table above for quick configuration and keep other
settings as the defaults, the following conditions apply:
•
The IP address of LAN port is 192.168.1.1 and the subnet mask is
255.255.255.0.
•
DHCP server is enabled; the DHCP address pool is
192.168.1.100~192.168.1.150.
•
The built-in NAT function will provide local computers with Internet
access via the single public IP of the WAN port.
•
The Filter Type is Listed Block and all the filters are disabled: No
filter rule is specified to block any packet. All packets can pass
through the WAN port.
•
There is no forwarding entry and any external access to your LAN is
blocked.
•
With the default values, the router (Access Point) can be easily
associated by a wireless client. For security concern, You should
modify the basic Wireless LAN security settings.