Sony CDX-4160 - Manual (Page 8)

8
Actual total number: Sony CDX-4160 ( E ,S,C,A) 3-859-005-11(1)
EN
Other Functions
Adjusting the sound
characteristics
You can adjust bass, treble, balance and fader.
Each source can store the bass and treble level
independently.
1
Select the item you want to adjust by
pressing (SEL) repeatedly.
VOL (volume) n BAS (bass) n TRE (treble)
n
BALANCE (balance) n FADER (fader)
2
Adjust the selected item by pressing (+)
or (–).
Adjust within three seconds after selecting
the item. (After three seconds, the buttons
work as volume control buttons.)
Muting the sound
Press (MUTE).
“MUTE” flashes.
To restore the previous volume level, press
(MUTE) again.
Changing the sound and
beep tone
Boosting the bass sound — D.bass
You can enjoy clear and powerful bass sound.
The D-bass function boosts the low frequency
signal with a sharper curve than conventional
bass boost.
You can hear the bass line more clearly even if
the vocal sound is the same volume. You can
emphasize and adjust the bass sound easily
with the D-bass control. This effect is similar to
the one you get when you use an optional
subwoofer system.
Moreover, the Digital D-bass* function creates
even sharper and more powerful bass sound
than Analog D-bass.
* Digital D-bass is available during CD playback.
Digital D-BASS Analog D-BASS
Level Level
0dB
D-BASS 3
D-BASS 2
D-BASS 1
0dB
D-BASS 3
D-BASS 2
D-BASS 1
Frequency (Hz) Frequency (Hz)
Adjusting the bass curve
Turn the D-BASS dial to adjust the bass
level (1, 2 or 3).
“D-BASS” appears in the display.
During CD playback, “DIGITAL D-BASS”
appears in the display.
To cancel, turn the dial to the OFF position.
Muting the beep tone
Press (6) while pressing (SEL).
To obtain the beep tone again, press these
buttons again.
Note
If you connect an optional power amplifier and do not use
the built-in amplifier, the beep tone will be disabled.
Turning on the clock
display
— Power Select Function
Only for cars with an accessory position on the
ignition key switch
To turn the Power Select Function ON
Press (OFF) while pressing (SEL).
The Power Select Function ties the clock
display power to the accessory position on
the ignition key switch.
To avoid battery wear, the clock is not
displayed while the unit is initializing.
Note
You cannot operate this function with the optional rotary
remote (RM-X2S).