A.J. Antunes & Co UF-216 9700435 - Manual (Page 4)

UF-216 water Filtration system
4
A.J. Antunes & Co.
P/N 1011078 Rev. B 03/12
ImpOrtant safety InfOrmatIOn
In addition to the warnings and cautions in this manual,
use the following guidelines for safe operation of the unit:
• Read all instructions before using equipment.
• Install or locate the equipment only for its intended
use as described in this manual. Do NOT use
corrosive chemicals in this equipment.
• Do NOT operate this equipment if it has a damaged
cord or plug; if it is not working properly, or if it has
been damaged or dropped.
• This equipment should be serviced by qualfied per-
sonnel only. Contact A.J. Antunes & Co. for repair.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
The following warnings and cautions appear throughout
this manual and should be carefully observed:
• Unplug the power cord before performing any
service or maintenance on the unit.
• All electrical connections must be in accordance
with local electrical codes and any other applicable
codes.
• WARNINg eleCTRICAl ShOCK hAzARD.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COUlD ReSUlT IN SeRIOUS INjURy OR DeATh.
- Do NOT modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
- Do NOT use an extension cord with this unit.
• If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualified person.
• This equipment is to be installed to comply with the
local plumbing code and any other applicable code.
• Water pressure must not exceed 100 psig (690
kPa). To reduce water pressure, install a water
pressure regulator and set water pressure to suit
application.
• The trans membrane pressure (inlet water pres-
sure minus the permeate water pressure) must not
exceed 45 psi (310 kPa).
• System should be supplied only with cold water.
• Commonwealth of Massachusetts Plumbing Code
248 CMR shall be adhered to. The use of saddle
valves are not permitted, please consult your local
plumber.
• A ground fault circuit interrupter (gFCI) must be
installed on the circuit to this system
• When installed on metallic plumbing, a properly
sized electrical bonding jumper must be installed
across the inlet and outlet pipes serving this device.