Hubbardton Forge 843007 User Manual

Installation instructions

Installation Instructions

F13

For Beacon Hall Paper Towel Holder 84-3007

Hand-Forged,

Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24304

To Install

Component Parts

A Paper

Towel

Holder

B Set Screw (2)
C Wall Mount Plate (2)

D Screws

(4)

E Wall

Anchors

(4)

1. Locate area paper towel holder (A) is going to be

mounted and mark center location.

2. Measure from center location 1 7/8” for center

location of first wall mount plate (C). From that
mark measure over 3 3/4" to locate center location
for second wall mount bracket (C).

3. Hold first wall mount plate (C) in location it is to

be mounted. With a pencil, mark the location of the
mounting holes in the wall mount plate (C) on the
wall behind. Do this for both wall mount plates
making sure the are straight and level from each other.

4. Put the wall mount plate down and drill 1/4"

holes in the locations marked on the wall if wall
anchors (E) are to be used.

If directly attaching

to a solid support the drilled hole is not
needed.

For holes using anchors, place the

tapered end of the anchors (E) into the holes and
gently tap them flush to the wall using a light
weight hammer.

5. Install screws (D) through wall mount plates (C)

and into each anchor (E).

If anchors are not

needed the screws (D) can be installed
directly to the wall.

6. Loosen two set screws (B). Screws are shipped

installed.

7. Slip paper towel bar (A) onto wall mount plates

8. Tighten set screws (B) on both sides of paper towel

holder (A) until against wall mount plates (C).

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

Hubbardton Forge will not be liable for injury or damage caused by improper installation or use of this fixture.

CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL INJURY
OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the building trade.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

(Figure 2)

(Figure 1)