AFX ANF192400L30D1LR - Manual

ANF / ATF / RHF / SAF Series
Flush Mount LED Ceiling Fixture
Page 1 of 1 8060802 R0
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing any part of
this fixture
B. Remove fixture and hardware bag from carton
C. Thread mounting screws (2) into junction box (not provided)
2. Wiring
All wiring must take place inside junction box. Caution: Make sure
power is off at fuse or circuit breaker box. Check power wires for damage or
scrapes. If power supply wires are within three inches of LED driver, use
wire suitable for at least 90C (194F). Note: Most dwellings built before 1985
have supply wire rated to 60C. Consult a qualified electrician before
installing.
A. This unit will not operate properly unless connected to a “grounded”
electrical circuit. Electrical shock, overheating, low or no light output,
and shortened lamp life can result if proper grounding is not done.
Securely attach green (or green and yellow) wire to ground supply wire.
B. Using wire connectors (provided), connect white (common) supply wire
to white fixture lead. Connect black (hot) supply wire to black fixture
lead. Do not mix wires. Pull on each wire lead to make sure connections
are secure. Make certain no bare wires are exposed outside of wire connectors. Note: fixtures with universal voltage power
supplies are pre-wired with a disconnect. Refer to the included guide for using the disconnect.
3. Mounting (Fig. 1)
A. Mount ceiling pan (1) to junction box using keyhole slots (3), and
tighten screws to secure pan to ceiling
4. Diffuser mounting (Fig. 2)
A. The diffuser (5) has three notches in its upper flange. Align these
notches with the mounting standoffs (4) on the outside of the
ceiling pan, and push the diffuser up against the ceiling
B. Rotate the diffuser clockwise or counterclockwise until the
standoffs rest within each diffuser slot
C. Twist slightly to ensure proper engagement
5. Power to the fixture can now be restored
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of
5 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure
due to improper installation, misuse, mishandling or damage incurred in transit.
Fig. 1
Fig. 2