Samsung RF4289HARS-XAA - Manual (Page 9)

setting up _09
01
SETTING
u
P
ASSEMBLE THE FLEx DOOR
To reattach the flex doors, assemble parts in reverse
order.
DISASSEMBLE THE FREEzER
DRAWER
1. Take out the upper
drawer by lifting it up.
2. Remove the tilting pocket ( 1 ) by pulling both
support guards ( 2 ) aside. And take out both
support guards by pulling them aside.
3. Take out the lower
basket ( 3 ) by lifting
the basket up from
the rail system.
4. Remove 4 hex head bolts
from both sides with a socket
wrench (10mm).
5. Lift up the freezer door from
the rails.
ASSEMBLE THE FREEzER DRAWER
To reattach the freezer drawer, assemble parts in
reverse order.
ADjuSTING THE LEVEL
Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refigerator is level both side to side and back to front.
If the refrigerator is not level, it will not be possible
to get the doors perfectly even, which may cause
moisture condensation and increased energy bills.
Below is an example of how to level the refrigerator if
the left side of the refrigerator is lower than the right
side.
How to adjust the level
1. Disassemble the freezer drawer. (See to page 8)
2. Remove the two screws
( 1 ) attached to the cover
leg front ( 2 ) with a Philips
screwdriver (+).
3. Remove the cover leg
front ( 2 ) by lifting the
bottom part of the cover
leg front up and pulling it
out.
4. Insert a flat-blade screwdriver (-) into a notch on
the left control lever, and turn it count clockwise to
level the refrigerator.
(You turn the lever clockwise to lower the
refrigerator and counterclockwise to raise it.)
Both control levers must be touching the floor
to avoid possible personal injury or property
damage because of tipping.
1
2
3
2
1
flat-blade screwdriver(-) control Lever
cAuTION
DA68-02520A(0.0)-EN.indd 9 2011.3.2 8:39:11 AM