APC AP9608 User Manual
Page 21
17
The System Status line at the bottom of the UPS Status and Diagnostics
screen can display the following Symmetra status conditions:
• Runtime Calibration
• Waiting to Power Load
• Smart Boost
• Smart Trim
• On-Line
• On-Battery
• Low Battery
• Replace Battery
• In Bypass
• Sleeping – Delayed Wakeup
• Sleeping – Inverter
Shutdown
• Forcing Graceful Shutdown
• Sleeping – Low Battery
Shutdown
• Overload – Unable
• Bad Power Module
• Intelligence Module is in-
stalled and failed
• Redundant Intelligence
Module is installed and
failed
• Bad Battery Module
• Load is above kVA alarm
threshold
• Redundancy has been lost
• Redundancy is below alarm
threshold
• Bypass is not in range (either
freq or voltage)
• Bypass contactor stuck in
bypass position
• Bypass Contactor stuck in
on-line position
• UPS in bypass due to internal
fault
• UPS in bypass due to over-
load
• System is in Maintenance
Bypass
• Input circuit breaker tripped
open
• System level fan failed
• The Redundant Intelligence
Module is in control
• IIC inter-module communica-
tions failed
• Turn on requested, override
required
• UPS will turn on automati-
cally when conditions are met
• Runtime is below alarm
threshold
• # of batteries increased
• # of batteries decreased
• # of power modules increased
• # of power modules decreased
• Intelligence Module inserted
• Intelligence Module removed
• Redundant Intelligence Mod-
ule inserted
• Redundant Intelligence Mod-
ule removed
• # of External battery Cabinets
increased
• # of External Battery Cabinets
decreased