Pro-Lite Gas Pricers - Manual (Page 6)

SETTING CONFIGURATION
There are 8 major setting in the configuration mode, to start configure, simply press
SETTING button and use up (↑) or down (↓) arrow key to choose from 8 different
system setting options:
Options General Function
Configuration (Technical Setting) To configure
1) Number of sign (pylon or
monument)
2) products (gas) per side
System Test Test or refresh PCU
Price Setting History Shows price history in each
product line with date and time of
the changes
Password Setting 1) Set password for admin and
user
2) To enable/disable password
function
Date & Time Setting To enter date and time of the
location where signs are installed
Dimmer Setting To adjust brightness of each PCU
Firmware Version Displays RC400 Firmware Ver.
Price Repeat Refresh Transmission Repeat times when
there is a transmission failure
I. Configuration
This section demonstrates how to configure PCU and indicate the number of
signs and number of products per side. Each sign can be single or double
sided. Enter the number of sign(s) or pylon(s) and enter the number of products
per side, the system will automatic determine the total amount of PCU by using
following equation:
Number of Product per Side x 2 (Double Sided) x Number of Sign = Total PCU in
one location.
If one side has three lines product and the other side only has two, you may
disable the third product line from the controller.
For example, if one location has two signs (pylons or monuments), each is
double sided with four products per side. And the password is 000000.
1) Press SETTING.
2) With default admin password (000000), the screen will prompt directly
to SETTING MENU without asking to enter password.
3) Press ENTER on 1 Configuration
4) Enter the number of sign (4 signs max) then down arrow key (↓) to
move the cursor to Product per Side and enter the product per side.
Page 4