Legacy Classic Furniture Dresser with Photo Mirror 481-1100C-0300C User Manual
Caution, Assembly procedures
Assembly Instructions For #481-0300/1100
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts
that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the assistance of one
or more persons in order to prevent personal injury and to insure parts are not damaged during the assembly process. If
dirty, clean finished parts with mild dishwashing liquid and water solution applied on damp cloth. Cloth should not be
excessively wet. Polish finish with soft cloth and an industry recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain
residue and rough surfaces and also check for staples or nails left after removing the packaging material. The
manufacturer will not be held responsible if preventative steps are not taken prior to installation.
Note 1:Use only the screws included in the package. Using different sizes could cause the wood to split or come out
from the other side.
Note 2: Phillips head screwdriver required for assembly.
Assembly Procedures:
Step 1: Position the mirror frame face down on a carpeted floor and position the wood supports on the back of the
mirror frame so that half of the wood support is below the post.
Step 2: Place mirror frame on dresser and align center marks on back of mirror frame and dresser.
Step 3: Attach the mirror frame assembly using wood screws.
The mirror is now attached.
---The End--