Altinex MT113-100 - Manual (Page 21)

MULTITASKER™
400-0209-002 20
20
22) [CLR] Reset card to default values
23) [RUP] Ramp volume UP to max (16)
24) [RUP=] Ramp volume UP to a value
25) [RDN] Ramp volume DOWN to min (1)
26) [RDN=] Ramp volume DOWN to a value
27) [RST] Stop ramping
28) [RAMP] Display ramp rate
29) [RAMP=] Set ramp rate
30) [TEST] Test internal memory IC's
31) [FBD] Feedback delay on/off
32) [RSI] Reset Card ID’s
33) [SIDn] Set all Card ID’s
34) [SIDnCi] Set one Card ID
35) [SID+] Set Card ID offset
36) [RSN] Read Card slot number
37) [HELP] Display available commands
Group Commands
38) [WR] Groups multiple cards
39) [RMC] Remove members from group
40) [RMG] Delete group
41) [RD] Displays group members
42) [CLM] Delete group
7.4 MENU MODE
MENU MODE commands are RS-232 commands
that allow virtually the same functionality as
programming commands. Unlike the programming
commands in the previous sections, 7.2 and 7.3,
MENU commands prompt the user to select from a
list of available options. The system then responds
based upon selections made by the user.
MENU commands may be issued in response to
prompts from within MTSetup™ or other RS-232
communication software.
The MENU driven commands are only available
with MultiTasker Front Panel systems that have the
following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command [VER]
from the Terminal Window. The system will
respond with feedback that is similar to the
following:
[690-0122-015 690-0123-004 690-0124-018]
Check the last three digits against the numbers
above to determine if the MENU MODE option is
available.
7.4.1 MENU COMMAND DEFINITIONS
Refer to section 7.2 for details on card functions
and examples. Following is a table cross-
reference of menu
mode sections versus
programming commands.
MENU COMMAND
Control
Select n/a
Save [CnS], [..S]
Clear [CLR]
Volume [VLOA], [VLBA], [VLTA], [+/-]
Loudness [LOD0], [LOD1]
Mute [MUT0], [MUT1]
Setup
Group [WR], [CLM]
Input Volume [VLImAn]
Ramp Time [RAMP], [RAMP=]
Status
n/a [VER], [C]
Help
n/a [HELP]