Daily maintenance, Periodic maintenance, Storage – Summers Disk-Chisel User Manual
Page 80: Daily maintenance -2, Periodic maintenance -2, Storage -2
4-2
SECTION 4 – MAINTENANCE
DAILY MAINTENANCE
1. Grease lift arms, walking tandem assemblies and hitch pivot.
2. Check all hydraulic components for leaks.
3. Check tightness of all wheel bolts.
PERIODIC MAINTENANCE
1. Repack wheel bearings and check tightness (See Page 6-21).
2. Check tire air pressure (See specifi cation page 5-2).
3. Check tightness of trip assembly hardware as explained under “Maintenance for after
the fi rst day and week of operation” (Page 4-1).
4. Check tightness of all hardware. Pay special attention to the hitch bolts and all pivot
retaining bolts.
5. Check coulter-chisel for damaged or worn parts. Replace as needed.
STORAGE
1. Clean and remove all excessive dirt and grease from coulter-chisel.
2. Grease all zerks.
3. To prevent rusting, repaint any areas that have been worn, chipped or scratched.
4. Retract cylinders when possible. Apply grease* to any exposed part of cylinder shafts.
*NOTE: Before returning machine into service, all grease must be removed from cylinder
shafts to prevent damage to seals.