AeroGarden 100610-SLR - Manual (Page 13)

Water Low Add Nutrients
Replace
Bulbs
Salad
Greens
Flowers
Vegetables Live Plants
Herbs
Raise lamp Hood (lights)
As plants grow to 1-2” from lights, raise Lamp Arm one Locking Button at a time. Be sure Lamp Arm is set on the
lowest Locking Button when starting your AeroGarden 6.
Unplug AeroGarden 6 and
remove Bowl from Base.
1
Raise Lamp Arm/Lamp Hood
by holding Lamp Arm & Hood
with one hand, and pushing in
Locking Button with the other.
2
Replace Bowl on Base and
plug in AeroGarden 6.
3
When “Replace Bulbs” light on control Panel begins blinking after 6
months of use…
• Unplug AeroGarden 6.
• Remove old Grow Bulbs and carefully discard.*
IMPorTAnT: To avoid burning, be sure Grow Bulbs are cool before handling.
• Insert new Grow Bulbs into Lamp Hood.
• Plug in AeroGarden 6 and press and release “Reset” button to restart
grow bulb timer.
Early Grow Bulb Replacement
If you replace Grow Bulbs before “Replace Bulbs” light illuminates, be sure to
restart grow bulb timer as follows:
• Press and hold “Lights” button until light next to your selected plant type
starts blinking – about 5 seconds.
• Release “Lights” button. The plant type selected light will continue to blink
for about 9 seconds. While plant light is still blinking…
• Quickly press and release “Reset” button. “Replace Bulbs” light will blink
once and the plant selected light will stop blinking.
Replace Grow Bulbs –
order bulbs at www.aerogardensupport.com
12
Push locking
Button in
*Check with local recycling authorities for
light bulb recycling availability in your area.
Basic Reminders About Your AeroGarden
(continued)