Symetrix SymNet I/O Card - Manual (Page 3)

Connections
QUICK START GUIDE: SymNet I/O Card
3
Input(s) on the card. Refer to the help module included in
all Symetrix software for more information on the Edge 4
Channel Digital Output Card and audio wiring.
4 Channel AEC Input Card
Connections:
Using standard mic/line cables terminated on one end with
terminal block connectors and appropriate connectors
for your mic/line sources on the other end, connect the
terminal block ends into the AEC Inputs on the card and the
opposite ends into your source devices’ outputs. Refer to
the help module included in all Symetrix software for more
information on the Edge 4 Channel AEC Input Card and
audio wiring.
2 Line Analog Telephone Interface Card
Connections:
Using a standard telephone cord terminated with RJ11
(6P6C) connectors, connect one end to the Line port on the
Analog Telephone Interface card and opposite end to the
telephone network (wall jack). Optionally, connect a standard
analog telephone, dialer, audible and/or visual ringing device
to the Set port of the Analog Telephone Interface Card using
another telephone cord.
Note: At this time, the SymNet 2 Line Analog Telephone
Interface Card is only certified for use with US and Candian
Public Switched Telephone Networks.
4 Channel Analog Input Card
Connections:
Using standard mic/line cables terminated on one end with
terminal block connectors and appropriate connectors for
your mic/line sources on the other end, connect the terminal
block ends into the Analog Mic/Line Inputs on the card and
the opposite ends into your source devices’ outputs. Refer
to the help module included in all Symetrix software for more
information on the Edge 4 Channel Analog Input Card and
audio wiring.
4 Channel Analog Output Card
Connections:
Using standard mic/line cables terminated on one end with
terminal block connectors and appropriate connectors for
your destination devices on the other end, connect the
terminal block ends into the Analog Line Outputs on the
card and the opposite ends into your destination devices’
inputs. These outputs are +4 dBu balanced line level outputs
by default. If you need an unbalanced output, or more
information on the Edge 4 Channel Analog Output Card,
refer to the analog audio wiring diagrams located in the help
module included in all Symetrix software.
4 Channel Digital Input Card
Connections:
Using 100-Ohm (balanced, AES) or 75-Ohm (unbalanced
S/PDIF) cables terminated on one end with terminal block
connectors and appropriate connectors for your digital
sources on the other end, connect the terminal block ends
into the Digital Inputs on the card and the opposite ends
into your source devices’ outputs. These inputs have a
nominal sample rate of 48 kHz. They will accept any input
ranging from 12 to 96 kHz and sample rate convert to the
nominal rate of 48 kHz. Refer to the help module included
in all Symetrix software for more information on the Edge 4
Channel Digital Input Card and audio wiring.
4 Channel Digital Output Card
Connections:
Using 100-Ohm (balanced, AES) or 75-Ohm (unbalanced,
S/PDIF) cables terminated on one end with terminal block
connectors and appropriate connectors for your destination
devices on the other end, connect the terminal block ends
into the Digital Outputs on the card and the opposite ends
into your destination devices’ inputs. These outputs use
a sample rate of 48 kHz by default. If you need a different
sample rate, connect an appropriate Word Clock, AES-3/11
clock or S/PDIF clock source to the corresponding Clock