GE 17453 Wireless Motion Sensing LED Spotlight - Manual (Page 3)

Hanging Keyhole Type Mounting
FOR BEST PERFORMANCE, SPOTLIGHT SHOULD BE POSITIONED
SO MOTION SENSOR IS ON TOP AND LIGHT IS ON BOTTOM.
First, use included template to mark the area where the
screws will be inserted.
NOTE: Spotlight can be rotated
360°, so screws can be mounted
in any position. We recommend
mounting the screws parallel to
the ground if mounting on a
vertical surface. Make sure the
screws are precise distance from
each other (2-1/8” apart). (E)
If using anchors:
Use 3/16” drill bit to drill holes
and insert anchors. Drive 25 mm
screws into anchors so that
screw head protrudes 1/8” from
surface (the height of the screw
head). (F)
c. Position the base in the chosen location and drive the
44 mm screw through the top of the base (D)
d. Replace the light fi xture by pressing the neck back
in to the base and replace the screw snuggly in to
the side of the base. DO NOT OVER TIGHTEN.
C D
E
F